光钎端口怎么修改模式

现有的H3C S5000的 24光电复用光口的状态

[H3C]display interface GigabitEthernet 0/24
GigabitEthernet0/24 current state: UP
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 7425-8af4-7fd7
Media type is SFP transceiver
Port hardware type is 1000_BASE_X
1000Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex type is autonegotiation
Inbound line-rate is disabled
Outbound line-rate is disabled
Flow control is disabled
The Maximum Frame Length is 1518
Forbid jumbo frame to pass
Broadcast MAX-ratio: 100%
Priority: 0
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID: none
Untagged VLAN ID: 1
Input(total): 39097748 packet(s), 8921117148 byte(s)
414080 broadcast(s), 350804 multicast(s), 0 pause(s)
Input(error): 171147 input error(s), 0 runt(s), 0 giant(s), 0 CRC
0 frame, 0 abort(s), 171147 ignored, 0 Jabber(s)
Output(total): 52978643 packet(s), 41620204509 byte(s)
38139 broadcast(s), 3094 multicast(s), 0 pause(s)
Output(error): 0 output error(s), 0 abort(s), 0 deferred
0 collision(s), 0 late collision(s)


现在要替换华为s5700
那我24号光电复用光口 应该怎么设置。
目前的配置是
[5F-N06-GigabitEthernet0/0/24]display this
#
interface GigabitEthernet0/0/24
port link-type access
#
return谢谢了